Need some advice.. about: Brake system...

[ChkUr6]

I'm a total NOOB when it comes to fixing things on my bike. I can do an oil change and replacing the air filter. But other than those 2, I really dont know how replace/repair things on my bike.

I'm planning on buying some Stainless Steel Brakelines for my bike..I just have some questions hopefully you guys and gals could answer..

1) How hard is it to install them?

2) Should the brake pads be replaced?

3a) If the brake pads should be replaced, What about the rotors??
3b)Are the rotors like car rotors? do they need to be shaved down or replaced?

4) After installing the new SS lines, same type of brake oil is used??

5a) What brand of SS lines are the most dependable brand? (Galfer??)
5b) What other brands are there??

6) Should I try to do this myself or should I take it to MOOMBA's?

Thanks...
:notworthy


*EDIT - Forgot to mention what type of bike... 2002 Honda CBR 600 F4i

[The Sauce]

1.) Not hard at all. May take some time for first-timers, and may get a little messy. Be sure to work carefully and use alot of rags.

2.) Brake Pads do not have to be replaced.

3a.) No need to change rotors, either.
3b.) No need to machine rotors.

4.) I usually use MOTUL RBF600, but any DOT3/4 brake fluid will work.

5.) Russell brakelines, of course :thumb feel free to ask any of our satisfied customers on this forum.

6.) This job is not difficult at all, however if you do feel like you would not be confident in doing it, hand it over to Moomba and they will do an excellent job :thumb

Good luck!

[tjtripp]

Brake lines are pretty easy to install. There should be someone willing to give you a hand. I did mine by myself, but an extra set of hands would make this a breeze. You don't necessarily need to replace the pads if they still have life left in them and I believe the rotor on bikes last longer due to the fact that they are cross drilled and are exposed to the air (they stay cooler). You will also use the same brake fluid (dot 4 or 4+) I'm sure someone close to you can help you out..

[The Sauce]

Oh yeah, installing Speed Bleeders makes the job a lot easier, too. :thumb

[Marmalade Dad]

Not much else to add, except:

Please do not reuse brake fluid. Please do not use brake fluid from a bottle that has been previously opened. Only use brake fluid that is brand new.

[D Duck]

and DONT get the fluid on any paint or plastics.

[ChkUr6]

5.) Russell brakelines, of course :thumb feel free to ask any of our satisfied customers on this forum.


You guys make'em for my bike??? i went to russellperformance.com and all they had was Auto and Harley parts...

[The Sauce]

You guys make'em for my bike??? i went to russellperformance.com and all they had was Auto and Harley parts...
We have a whole new application chart for sportbikes which has not been uploaded to the website yet. To inquire about the purchase, email me JEvangelista@<hidden>

[Earl]

Only other add here is to use the right brake fluid for your bike.

Having a Mighty Vac for bleeding the newly installed brake lines certainly makes things easier.

[pantablo]

check this out for an idea how difficult it is. I did mine with help of someone that knew what they were doing.

http://www.bayarearidersforum.com/forums/showthread.php?s=&threadid=69233